For Open Ends cut lines, if you create them as From Curves or Projected, you may need to adjust the ends of the cut line to make it meet an edge correctly, especially for 4- and 5-Axis machining.
Click Specify Ends.
Use the following commands on the CUT ENDS menu:
Start—Specify the end condition for the beginning of the cut motion.
End—Specify the end condition for the end of the cut motion.
Use the following commands on the CUT START or the CUT END menu:
On—Use the default start point or end point for the cut motion.
Specify—Manually relocate the start point or end point for the cut motion. You can move the mouse and extend the starting segment, displayed in green. When you select a new location for the point, use the commands on the END DIM TYPE menu (Ext Length, Offset Plane, or Offset Csys) to specify the dimension type for the end.
When satisfied, click Done/Return on the CUT ENDS menu.
See Also