Selecting holes by Diameters, Surfaces, Parameters, and Auto Chamfer implies specifying a rule for hole selection. For example, if you specify a diameter value, the system will search the model for the holes of this diameter and include them in the Hole Set. If you select a surface, the system will include all holes on this surface. If you specify a combination of rules, the system will look for holes that satisfy all of them; that is, if you specify a diameter value and select a surface, the system will include only the holes of the specified diameter that are located on the selected surface.
The Axes method lets you explicitly select and unselect hole axes, regardless of other rules used in Hole selection.
When you select Groups, the system copies the rules used for defining the selected Drill Group, as well as explicitly selected and unselected axes, into the current Hole Set, and applies them to the model according to the principles described above.
Selection by Points can not be used in combination with any of the other selection methods.